MINI-CLIK® RAIN SENSOR The Simplest Way to Automatically Stop Irrigation During Rainfall Irrigating a landscape during a rainstorm not only results in oversaturated plants and turf, it also wastes water. Hunter’s Mini-Clik rain sensor provides the simplest, most effective way to prevent sprinklers from running during or after any level of rainfall. · Hunter mini clik rain sensor manual The Mini-Clik is an accurate rain gauge and can be verified by setting up a “tube” type rain gauge in the same vicinity and making periodic readings. MINI-CLIK® RAIN SENSOR INSTALLATION CARD Introduction In most installations, the Mini-Clik sensor acts as a switch that breaks the circuit to an irrigation system's solenoid valves in response to rain. This allows the timer to advance as scheduled, but keeps the valves from opening the water flow. Once the Mini-Clik has dried sufficiently, the File Size: KB.
Wiring to the Hunter SRC The Mini-Clik connects directly to the SRC. This allows you to easily override the sensor by using the RUN (BYPASS SENSOR) position on the dial. 1. Route the wires from the Mini-Clik up through the same opening used for valve wiring. 2. Connect one wire to the RS terminal and other to the C terminal (See Figure 1). 3. C onecth val m. Wireless Rain-Clik Components Wireless Receiver 1. Bypass Button: Allows automatic or manual watering when the sensor is active. 2. Receiver Status LED: Used to indicate the status of the sensor. 3. Receiver Bypass LED: Indicates when sensor has been bypassed. 4. Radio Antenna: Receives a wireless signal from the. In most installations, the Mini-Clik acts as a switch breaking the circuit to solenoid valves of an irrigation system when it rains. This allows the timer to advance as scheduled, but keeps the valves from opening allowing water to flow. Once the Mini-Clik has dried, the switch closes again to allow for normal operation.
Manual – Single Station – Allows user to activate a one time watering A Hunter Mini-Clik® rain sensor can be connected to the SRC. The. This mounts on or next to the controller, and by simply moving the switch, the Rain-Clik is bypassed. Note: Using the “manual” switch on non-Hunter controllers. Once the rain sensor has dried sufficiently, the switch closes again to allow normal operation. Compatible Hunter rain sensors include the following: Mini-Clik®.
0コメント